Perguntas más frecuentes

It is a Next-Generation polymer mortar, READY FOR IMMEDIATE USE, which has the same functions as a conventional mortar or adhesive to seal masonry.

The main advantages are economy, speed and safety.
The SOLDABLOC mostar presents:
Excellent structural strength.
Laying speed up to 3 times faster.
Lower cost per square meter of wall.
Economics in plastering mortar.
Anchoring bricks / blocks in concrete pillars without using screen, clip, etc.
It does not generate waste.
Do not generate dirt.
It is more environmentally friendly.
Results in less structural weight.

The SOLDABLOC mortar was developed with a single technology combining polymer composites, mineral fillers and additives.

No, SOLDABLOC mortar receives no derivative of cement

The SOLDABLOC mortar has been specially developed for sealing masonry (walls) for ceramic, concrete and ecological blocks.

Yes. The mortar is ready to use, requires NO water, mixing or additives.

1.5kg of SOLDaBLOC will be sufficient for up to 2,0m² of masonry, considering a ceramic block of 19x39 cm which equal to about 15 linear meters of mortar.

The SOLDABLOC mortar drying process occurs in contact with air. After 15 minutes the drying process is already such that prevent nesting. Thus, it is suggested that to open a row within a time of 10 to 15 minutes to put the blocks.

The horizontal joint formed by SOLDABLOC mortar between the blocks is thin, but ensures no contact between the blocks. This joint varies between 3 and 5 mm and ensures that the structure works without generating cracks in the future. The chemical characteristic of SOLDABLOC mortar ensure a less brittle behavior than conventional mortar.

Masonry can be constructed using dry joints (without mortar) up to 3 mm, i.e., filling the vertical joint keeping a distance of only 3 mm for accommodation and variations dimensional and thermal is not necessary. It is recommended the application of vertical joint especially in the first and last row and the in blocks together to pillars.

By removing an already seated block it is necessary to clean and reapply the 2 mortar cords.

The SOLDABLOC mortar application speed is about 4x higher than the conventinal method and it is recommended to wait 10 to 15 minutes for every 1.5m of wall height. In the meantime another wall could be erected without loss of productivity.

Once the SOLDABLOC mortar is READY-To-USE, you could cut in half the manpaower necessary to erect any kind of wall.

Full cure of SOLDABLOC mortar is 72 hours, and after 02 or 03 hours the wall is already firm enough to receive plaster, etc.

The SOLDABLOC mortar meets all the requirements for use in sealing masonry. The SOLDABLOC mortar is classified as polymer mortar with the only difference of being ready for use. To learn about the reports of technical tests, please contact our sales department

Because SOLDABLOC is a polymeric product, and therefore more flexible than conventional mortar, the ability of SOLDABLOC mortar to accommodate tensions is higher, even with only two threads. This fact is evidenced in the compressive strength tests with different types of blocks, where SOLDABLOC mortar prisms reached similar resistance or superior to conventional mortar prisms resistance.

Kept in it's original packaging or an air-tight package, SOLDABLOC can be stocked for up to 6 months. After opening the package durability is up to 10 days.